Details

---

Specifications

• Weight (kg) 0.2800
• Master Carton MC 50
• Pal 900
• Transistor hFe measurement YES
• AC voltage measurement 0-500V
• DC voltage measurement 0-500V
• 0-2MΩ resistance measurement
• DC 0-5A
• Continuity test YES
• YES diode test

The YT-73080 universal meter with a manual range for each measurement allows you to perform basic and advanced electrical measurements. This is the basic model in our offer. Additional protection against mechanical damage is the so-called holster - a rubber casing pulled over the casing of the device.

BASIC MEASUREMENTS

• Alternating voltage measurement: A.C. 0-500V
• DC voltage measurement: D.C. 0-500V
• DC current measurement: D.C. 0-5A
• Resistance measurement: 0-2MΩ
• Diode test: IF 1mA, UR 3V
• Continuity test: 0-30Ω

ADDITIONAL MEASUREMENTS

• hFe transistor test: 0-1000, built-in test socket
• square wave generator: 5Vpp, 50Hz

MEASURING ACCURACY

• Example of Accuracy Determination for AC Voltage Measurement. Calculations for the measurement result: 235V
• the measurement accuracy of the YT-73080 meter for this range is: ±(2% + 10), resolution 1V
• Calculation of measurement error formula: (measurement result x 2%) + 10 x resolution
• calculation: (235 x 2%) + 10 x 1 = 4.7 + 10 = 14.7V
• The result taking into account the measurement error for the indication 235V = 235 ± 14.7V*
• the result taking into account the measurement error for the DC voltage measurement indication: 12V = 12 ± 0.146V
• The table with the resolution and accuracy for a given measurement can be found in the instruction manual.

*The YT-73080 meter does not have the true rms measurement function, therefore the above result is the real effective value of the AC voltage only for the correct sinusoidal waveform.

BUILT-IN FUNCTIONS

• Waveform generator - setting the knob to generate a signal will cause the meter to generate a square wave with a peak-to-peak voltage of 5Vpp and a frequency of about 50Hz. The signal can be used in audio technology, e.g. in loudspeaker diagnostics
• DATA HOLD [H] - saving the currently measured value on the display

ADDITIONAL INFORMATION

• LCD display, maximum displayed score: 1999
• sound signal in the circuit continuity test for resistance below 30Ω
• automatic switching of the diode test to the continuity test when the circuit resistance is below 30Ω (it is not possible to set the meter to diode test only)
• measuring probes included
• design with overload protection
• housing made of ABS plastic + so-called holster, i.e. a rubber casing protecting the meter against mechanical damage
• low battery indicator
• power supply: 9V(6F22) battery

CAUTION
When measuring unknown values with a meter with a manual range change using the knob, measurements should be made sequentially from the largest range to the range giving the most accurate result - otherwise you risk damaging the device.